The water tank wire drawing machine equipment has varying degrees of relative sliding between the steel wire and the drum during the drawing process, and during operation, the steel wire, drum, and drawing die are all immersed in the cooling lubricant or sprayed by it, so it is called It is a water tank wire drawing machine.
The structure of the water tank wire drawing machine is very compact and occupies a small area. The drawing density of the entire equipment is high. The steel wire will not twist during the drawing process so that high-speed drawing can be performed.
Because of the horn, the process is carried out in cooling lubricant. The cooling and lubrication conditions of the steel wire are very good, and the quality is guaranteed.
Correct Operation of Water Tank Wire Drawing Machine
When the water tank wire drawing machine equipment is working, the water tank must be filled with water, then soak the soap, pour it into the water tank, arrange the drawing mold, place the raw materials on the pay-off frame, then roll the tip through the mold to open the main machine, and pull it out through the mold 2 meters, place the mold on the grate, wrap the silk around the cone wheel twice clockwise, and then thread the second mold. On this basis, pull out the silk number you need.
After threading one mold, wrap it around the water barrier. On the take-up tank, start the take-up tank.
In order to ensure the stability of its water tank wire drawing machine, we need to flexibly control it so that we can achieve the purpose of coordinated work.
During the operation of the water tank wire drawing machine equipment, it also needs to use coolant for heat dissipation to prevent The quality of the drawn products is adversely affected. In addition, when rewinding, we need to use a small-power motor to drive, so as to ensure constant tension on the wire during rewinding.
During the debugging process of the water tank wire drawing machine, the problems involved in starting, stopping, or disconnection detection should be completed by the PLC.
During debugging, the start signals of the main drawing and winding of the water tank wire drawing machine are kept in parallel, so they will be started at the same time.
Before starting the water tank wire drawing machine, you should carefully check whether the various fasteners on the equipment are tightened well and whether the transmission components can rotate flexibly. In addition, you should also check whether the lubricating oil lines, cooling lines, and pneumatic lines are smooth, whether there are leaks, and whether the electrical wiring is normal.
After confirmation, the water tank wire drawing machine equipment can be started.
