To a certain extent, in order to ensure the stability of the water tank drawing machine, we need to control it so that we can achieve the purpose of coordinated work. During the operation of the water tank wire drawing machine, coolant is also needed. Carry out heat dissipation to prevent the quality of the drawing product from being adversely affected.
In addition, when rewinding, we need to use a small-power motor to drive, so as to ensure constant tension on the wire during rewinding.
When debugging the water tank wire drawing machine, we first need to combine the actual process requirements, especially the line speed that can reach a certain level, to calculate the operating frequency required by the main drawing frequency converter; secondly, we need to refer to the actual process requirements of the water tank wire drawing machine. The transmission ratio is used to find the frequency required for winding.
In addition, it should also be ensured that the acceleration and deceleration time of the main pull inverter is as long as possible. Therefore, we can perform smooth acceleration and deceleration.
During the debugging process of the water tank drawing machine, the problems involved in starting, stopping, or disconnection detection should be completed by the PLC.
During debugging, the start signals of the main drawing and winding of the water tank wire drawing machine are kept in parallel, so they will be started at the same time.
Before starting the water tank wire drawing machine, you should carefully check whether the fasteners on the equipment are tightened well and whether the transmission parts can rotate flexibly.
In addition, you should also check whether the lubricating oil lines, cooling lines, and pneumatic lines are smooth, whether there are leaks, and whether the electrical wiring is normal. After confirmation, the water tank wire drawing machine equipment can be started.
The main pulling and winding inching signals of the water tank drawing machine can be used during threading. When rewinding, the required strength is set by the touch screen PLC.
The water tank drawing machine is different from the pulley type wire drawing machine in that the steel wire and the drum have different degrees of relative sliding during the drawing process (the finished drum is an exception), and the steel wire, the drum, and the drawing die are all immersed in the cooling water during operation. It is in the lubricating fluid or sprayed by it, so it is called a water tank wire drawing machine.
