During the installation process of the wire drawing machine, its foundation is fixed very stably, which can effectively avoid its vibration. During installation, it is necessary to make the stretching axis of the wire symmetrical to the center line of the die hole through debugging, so that it can make the stress on the wire and the wire drawing die act evenly.

During the drawing process of the wire drawing machine equipment, frequent starts and stops should be avoided, because the friction caused by the tensile stress at the start of drawing is much greater than the friction during normal drawing, which will inevitably increase the wear of the mold.

In addition, the wire used for drawing must undergo pretreatment: surface pretreatment and heat treatment.

During the surface pretreatment of the wire drawing machine, wires that are dirty on the surface and have a lot of impurities attached to them must be cleaned and dried before drawing.

For wires with a lot of oxide scale on the surface, they must be acid-thinned and dried before being drawn.

For wires with peeling, pits, heavy skin, etc. on the surface, they must be polished with a polisher before being drawn.

Heat treatment of wire drawing machine: For wires with excessive hardness or uneven hardness, the hardness must be reduced by annealing or tempering first, and the wire must maintain good hardness uniformity before drawing a mechanical device. The control system can provide a very accurate And smooth linear speed is valuable, and the wire drawing machine is one such device, and its system has very high requirements for speed control.

The entire system of the wire drawing machine is relatively complex, and the control equipment requires coordination between the various motors. The system is controlled by four servo motors, which can fully meet the real-time interaction between data.

To ensure that the trackside siding lines are in place according to the algorithm, it is required that the line of wires can be calculated quickly.

Make full use of the servo’s internal firmware function and calculate it by the driver itself, greatly omitting the total time calculated by the line position of the traditional wire drawing machine control system.

The command is then sent to the driver, ensuring the line is to minimize latency through the controller.