The straight continuous wire drawing machine can effectively control the second flow rate of metal in each drum during operation.
During the drawing process of the steel wire, it first winds the steel wire from a drum to a certain circle.
After a few seconds, it goes directly to the next wire drawing die through the tuning roller, because the wire drawing die will be subject to uneven wear, fluctuations in the speed of the motor, or some other factors, which will destroy the balance of the metal second flow. , then it will definitely cause the tension of the steel wire to change.
In fact, this change mainly reflects the swing amplitude of the tuning roller.
Precautions for operating the straight continuous wire drawing machine
Before starting the straight continuous wire drawing machine, it is necessary to check the cooling water, drum, air pressure, and motor belt of the equipment, as well as the smoothness of the cooling water in the circulation system and whether there are impurities on the drum.
The main thing is whether the safety protection device is flexible enough. According to the main drawing process, the blank wire is directly loaded onto the pay-off frame and inspected accordingly.
In the process of completing the threading of the straight continuous wire drawing machine, the wire must go around the reel and be tightened.
To a certain extent, the meter value must be designed according to the actual requirements of the product, and then the meter value must be designed.
Use a meter to control; the entire drawing speed must be reasonable enough to avoid any impact on the quality of the drawing; during the drawing process, lubrication should be observed at all times, and the amount of cooling water must be sufficient.
The straight continuous wire drawing machine is not only efficient and high-speed, but does not require twisting and twisting to a certain extent. Mainly because of its strong cooling and high cost performance, it is a very slip-free continuous wire drawing machine, which is very popular in the entire metal products industry.
The applications obtained are quite extensive.
If compared with the pulley-type wire drawing machine, whether it is in terms of production efficiency, production cost, or product quality, the straight-in wire drawing machine has the absolute advantage, because it processes the hardening rate of steel wire is relatively low, so it has good plasticity and toughness, and the fluctuation range of strength is also very small.
The performance of the entire processed product is still very stable.
