It is commendable that the control system of the inverted wire drawing machine can provide a very accurate and smooth linear speed during operation. The inverted wire drawing machine system has very high requirements for speed control. The entire system is relatively complex, and its control equipment coordination between various motors is required.

The system uses four servo motor controls, which can fully meet the real-time interaction between data. In order to ensure that the track side siding lines are in place according to the algorithm, it is required that the line of wires can be calculated quickly.

The inverted wire drawing machine makes full use of its servo internal firmware function during operation, and the calculation by the driver itself greatly omits the total time calculated by the line position of the traditional wire drawing machine control system.

The command is then sent to the driver, ensuring the line is in order to minimize latency through the controller.

The main contents of the safe operation guide for inverted wire drawing machine

Whether the different lubrication points are completely lubricated, whether the pressure of the water circuit and the air circuit is normal, and whether the drop rack on the trolley is complete. After turning on the power of the equipment, turn on the main AC motor, and then ensure that it is in an inverted position. The wire drawing machine can run without load for a period of time to facilitate detailed inspection of the equipment.
The main machine in the inverted wire drawing machine system, should be started slowly, and then it can be gradually increased to reach the final normal operating speed.
Operators must wear corresponding protective gloves during the entire operation to prevent burns to the human body or impact on the product in appropriate quantities.
When the inverted wire drawing machine system is pneumatically operated, check the abrasive belt on the swing. Once problems are found, they should be solved and dealt with promptly and effectively. During the operation of the inverted wire drawing machine, the operator is not allowed to stand. At the direct exit of the wire drawing machine, prevent the workpiece from flying out and causing harm to the human body.
When the same inverted wire drawing machine system is working, the working pressure must be closely observed and cannot exceed the range of the red line, so as to avoid accidents. During the operation of the wire drawing machine, it can’t be inspected and repaired.
If the inverted wire drawing machine is not needed for a long time, its main power supply can be completely turned off.