In order to ensure the normal operation and production efficiency of the equipment, the inverted drawing machine installation is very important. The following is an introduction to the drawing process and the inverted drawing machine installation requirements:
The main principle of the inverted wire drawing machine during its working process is to effectively control the second flow rate of metal in each drum. During the drawing process of steel wire, the steel wire will first be wound from a drum to a certain number of turns, and then directly enter the next drawing die through the tuning roller, because the drawing die will be unevenly worn, or Fluctuations in the speed of the motor or some other factors will destroy the balance of the metal flow, which will definitely cause changes in the tension of the steel wire. In fact, this change mainly reflects the swing amplitude of the tuning roller.
The inverted wire drawing machine is one of the more difficult to control among all wire drawing machines, mainly because its equipment requires multiple motors to stretch the metal wire at the same time, so the overall work efficiency is relatively high. The difference between the previous looper-type wire drawing machine and the water tank wire drawing machine is relatively large because it allows the metal wire to slip between different molds. Moreover, the inverted wire drawing machine has relatively high requirements for the synchronization of the motor and the speed of dynamic response. Because stainless steel is relatively brittle and lacks the toughness of high-carbon steel wires or steel cords, it is more likely to break during operation.
Inverted Drawing Machine Installation
Before installing the inverted wire drawing machine, you must first choose the appropriate location, place the equipment we selected on a stable ground, and then install it according to the instructions. First, use the appropriate expansion method according to the foot holes of the machine base. Screws are attached to the pre-laid cement foundation to hold it in place. Then check whether the equipment can maintain a stable state and whether all auxiliary equipment is complete. When tightening the equipment, attention should be paid to adjusting the position of the main machine to ensure that the center of the drum and the rotation center of the trolley are at the same position. At the same time, please note that when adjusting the main unit, you should ensure that the trolley can remain smooth during its forward and backward movement.
In addition, it is necessary to properly connect the electrical circuits of the equipment in accordance with the electricity requirements to ensure that there are no leaks or short circuits. With the continuous development of technology and technology, people have higher requirements for the process quality of various metal products. At the same time, as a commonly used equipment, its process technology level, product quality, output, and variety have also made great progress.
