Speaking of High Speed Wet Wire Drawing Machine equipment, we will introduce some knowledge about the operation of the product in this article, hoping to help you understand the equipment more deeply through this study, and at the same time understand To the operation requirements of High Speed Wet Wire Drawing Machine.

In the end, some useful knowledge can be obtained and can be applied to actual work of High Speed Wet Wire Drawing Machine.

Obviously, only by mastering the operation skills proficiently, can we explore the potential of the equipment to a greater extent, so that it can help us complete work tasks better.

Let’s take a look at the specific content together.

First of all, before turning on the high-speed water tank type wire drawing machine equipment, don’t forget to check it first. The main inspection contents include: whether the oil level, pressure and lubrication are normal, whether the safety protection device of the equipment is normal, etc., if any Abnormalities should be repaired in a timely manner.

Before officially entering the working state, we need to check whether the equipped molds meet the production requirements, so as to reduce unnecessary troubles.

When it is determined that there are no abnormal problems, turn on the power supply for the high-speed wet wire drawing machine equipment as required, and operate in accordance with the requirements and sequence, and there must be no violation of regulations, otherwise the performance of the equipment may be affected.

After the equipment is started, it should run without load for a while, and pay attention to observe its operating status.

It should be noted that we should always check whether the liquid content in the water tank of the high-speed water tank type wire drawing machine equipment is sufficient, and add it in time.

In addition, the speed control knob on the top of the equipment should be adjusted to the middle and low speed position first, and then adjusted according to the actual situation until it finally reaches the normal operating speed.

The staff need to pay attention to observe the operating status of the equipment.

What needs to be reminded is that if there are some abnormal problems during the operation of the high-speed wet wire drawing machine equipment, such as water leakage, oil leakage, abnormal noise, etc., the equipment should be shut down in time and repaired.