Load-bearing Performance and Configuration of High-speed Inverted Wire Drawing Machine
The inverted wire drawing machine can reduce the diameter of metal wire by 1 to 2 mm.
This can generally be achieved by using a circular mold. The diameter of the mold required for the finished product is determined by installing it in the mold box of the high-speed inverted wire drawing machine.
Then the steel bar is rolled and threaded, and the high-speed inverted wire drawing machine starts to work and the wire is taken up at the same time. The finished product is the wire rod with the required diameter.
In practical applications, the model of the high-speed inverted wire drawing machine is selected according to the required load-bearing capacity.
Usually, the larger the diameter of the processed steel bar, the greater the load-bearing capacity of the equipment.
When pulling steel bars, the force borne by the equipment is also different depending on the diameter reduction of the steel bars.
At present, many users prefer to use new frequency conversion inverted wire drawing machines.
The main structural components of the variable frequency inverted wire drawing machine are as follows: the wire drawing machine uses a squirrel-cage natural wire pay-off frame; the wire take-up part adopts double reel wire take-up, driven by a torque motor, and the wire take-up reel is controlled by a torque controller speed and tension.
The cable arrangement system adopts a light rod step-less cable arrangement.
The wire drawing lubrication of the high-speed inverted wire drawing machine equipment is provided by a dedicated circulating oil system. The wire drawing machine equipment control system consists of 10 frequency converters to control the speed of each wire drawing machine through single-action and linkage potentiometers.
The wire drawing equipment is composed of 10 separate wire drawing machines.
Each machine has its reducer, motor, belt drive, drawing pot, wire mother seat, etc.
During use, the specific configuration of the variable frequency inverted wire drawing machine unit can be adjusted accordingly according to the requirements of wire drawing operations.
The wire drawing unit can also be composed of 6 units, 8 units, etc., which can be determined according to user needs.
If actual conditions permit, it is recommended that the distance between two high-speed inverted wire drawing machine be kept within the range of 200 to 400mm, but the shorter length of 10 units is 12 meters. The equipment is installed according to the foundation diagram.
Check whether the lubricating oil of each bearing is sufficient, inject the appropriate amount of gear oil into the transmission, check whether the screws are loose, whether the wire arrangement of the drawing pot is smooth, and turn the inching switch to see whether the steering is forward. After the inspection is completed, start production again.
